Battery can not flush electricity is how to return a responsibility

Battery can not flush electricity is how to return a responsibility

The battery does not charge, can not maintain enough capacity, affect the normal work of the reasons are:

Insufficient charging current: because the generator is too weak or does not generate electricity in the work, it will promote the charging current to reduce or do not charge at all; In addition, the external insulation is damaged, resulting in a short circuit, reducing the charging current or can not be charged. At this time, it is necessary to check the tightness of the generator belt, whether the line joint is loose and falls off, and whether the cylinder head contact is good, so as to keep the rated current output of the generator. Battery capacity, can be measured electro-hydraulic specific gravity and single cell voltage to determine, if the electro-hydraulic specific gravity is low, single cell voltage is insufficient, the application of small current repeated 3~4 times charging and discharging, in order to restore the normal performance of the battery.

Interceptor contact is not closed: When the output voltage of the generator exceeds the voltage of the battery, the battery should be charged, and the ammeter points to the "+" pole. Such as the interceptor coil short circuit, iron, contact gap, air gap and contact spring tension is too large so that the contact can not be closed, resulting in no charging. Should check the line, eliminate short circuit, bonding, adjust the contact gap and air gap, reduce the tension of the contact spring arm. If the interceptor contact has been closed, still can not charge, indicates that the contact is too dirty, bad contact, should be cleaned.

Wood partition damage, plate warping vulcanization: electrohydraulic proportion is too large and internal short circuit, so that wood partition corrosion, damage and plate vulcanization, so that the battery can not charge. At this time, the connecting strip and the upper cover should be disassembled and the wooden partition should be replaced.

Plate warping vulcanization, mainly due to charging, discharging too fierce, battery parking for too long, electrohydraulic impurity, the proportion is too small and high temperature reasons. Make the plate hard and brittle, produce cracking deformation, active material oxidation, fall off and paste. Cause plate pore plugging, electrohydraulic should not penetrate, increase the internal resistance. Charging voltage is too high, the temperature is too high, premature bubble; When discharging, the voltage drops fast, the battery capacity is reduced, the current from the engine can not be too long, periodically check the electrohydraulic specific gravity and liquid level height. For the temporary use of batteries, to sufficient electric exile in dry storage, and to charge once a month, in order to restart, to achieve normal quality.